How much would it cost to get a tinny/tinnie boat ... - Oil Painting Salon

If plain aluminium then you need to clean the surface – normally with an acid such as hydrofluoric <a href="http://www.monclerjacketscoats2011.com/"><strong>moncler coats discount</strong></a> (MUST use protective clothing, gloves, goggles etc.) and flush well. If painted remove loose material and sand to create a key for the next step. Repair any cracks, splits, loose rivets. Use a quality etch primer for alloy – spray just enough to cover, but no more than an even mist coat – it’s not paint and you should see through it. This gets used only on any bare alloy. Depending on the system you have chosen you may apply an undercoat prep layer over the lot to ensure even adhesion of the finish layer(s). At least two top coats should be applied as per directions of the maker. Stick to one brand throughout. Polyurethanes are pretty <a href="http://www.monclerjacketscoats2011.com/"><strong>moncler discount</strong></a> tough and reasonably safe to use – but use full PPE anyway as no coating system is without danger. Don’t breath dust or vapours, don’t get on skin or in eyes. House paints are not designed for this use. Enamels are soft and won’t resist abrasion. Two pack products are very toxic and pricey, and are better left to the professionals unless you are right <a href="http://www.northfacesales-discount.com"><strong>north face sales</strong></a> up to speed with the risks – the results are fantastic but this gear is hard to use even for the pro. Cost will depend on materials, and if you do it or a professional. Should be 200-300 odd for materials, probably the same or a little more for labour – but there are a lot of variables without seeing it. Good luck.