AutoCAD Plant 3D 2011 Concise Guide (2 )

Chapter 2, Project Settings
before setting the project apt detect out, in AutoCAD Plant 3D 2011 in the vegetation design process.
Step 1: Open the AutoCAD Plant 3D, set up the project
Step 2: Create Project Graphics
- input>
- Ribbon> piping
- Ribbon> hit points in the prototype; press ENTER key to complete the
Step 6: Insert the valve or pipe fittings
- tool palette or the functional areas> > - Select Valve> Iso tab> cross-graph
entire the on is the contents of plant design, of lesson, the output BOM table, describing in elaborate later. This chapter describes the project settings.
open AutoCAD Plant 3D 2011, click the indicator shown underneath.

New Project look below:

click New Project, then the following

aggregate of five settings, is not interpretable in Chinese,GHD IV Styler, should be noted that the project set itself a place in a divide, not mingled with other documents is a good habit, I set the following figure:

then click Next, the premier two settings, is to prefer to use English or metric, of course,GHD Rare Gift Set, use the metric system in our nation.

click Next,GHD Blue Styler, on page 3 to set the location of P & ID documents, can be used before the P & ID design files on it. We begin from scratch, directly with the default just fine.

Next,GHD Hair Straightener, set the 3D document page 4, the chart document position,GHD Ireland, also using the default settings above it:

Step 5, whether you must set additional items, check in there to convert, we do no absence a direct point of completion can be, it namely quite easy,GHD Salon Styler, the end of this part.
return to the main directory