Summary of experience in fitting 99

1, waterproof film construction should accept the deep water;
2, waterproofing ought be secret after completion and approval of construction;
3, waterproof construction to do 24 hours after completion of elementary water testing;
4 , bathroom waterproof wafer should not be less than 1.8m;
5, floor drain, Yin-Yang angle, pipe should do it again at the water;
6, floor drain floor drain should be used Fangchou;
7, the right of hot and cold water pipes Left cold heat;
8, water from the ground and try not to go;
9, the cold water pipe in the wall should be 1cm layer of protection, hot water pipes to 1.5cm;
10, PPR pipe to be installed consider the thickness of stickers, prepared to tile, so the tube will not be exposed;
11,GHD Benefit Straighteners, the sink must be for large for possible;
12, and the basin guiding to complete, or simulate not to go;
13, the toilet installation can not use cement, use silicone (pearly);
14, after going to toilet faucet installed to defend the (product protection);
15, to consider when buying toilet toilet from the pit;
16, rinsing machine to consider is the drainage or the next drainage;
17, the bathroom is best not to tel, and easy to damp;
18, to consider a good size bathroom mirror, mirror front lamp is easy to install or higher;
19, toilet pipe is best to stay manholes;
20, strong, languid can not wear a pipe inside the same;
21, the left ground zero on the right phase;
22,GHD Rare Straighteners, to 300 from the power channel, alternate 1.4 m;
23, switch not installed in the door behind;
24, outlet should be a lot of good;
25, with a 16A high-power electrical outlet;
26, dark pots to use good;
27, dark boils to reserve the table complete, or is not installed on;
28,GHD Purple Straighteners, PVC pipe threading wire cross-section, not more than threading pipe cross-sectional place of ​​40%;
29, bedroom air-conditioned not to implantation ;
30, climate holes to consider the mundane tilt, or drainage will flow in.;
31, light too consider the twin control;
32,GHD Diamond Flag 2011, the best bathroom installation splash;
33, balcony to consider a protective tube;
34, bad wire to flat, vertical;
35, to consider the prevalent flue Shangni valve;
36, bought appliances must look at the manual personnel;
37, manual insurance card must be kept well;
38, cement creation phase exceeding three months can not be accustom;
39, differ varieties of cement can not be mixed;
40, some sand try to use savor to know his mouth dirt;
41, wall and floor tiles to be dried and overran more than 2 hours to paste;
42, wall and floor tiles fewer prefer than buy some do not arise to buy or color;
43, a wall can not have two non-whole bricks;
44, instantly after achievement of exploration coupler clean up of the tile;
45, the floor glue marble (light) waterproof stone back to do;
46, Yang turn to cut 45-degree angle;
47, floor tiles to the floor drain at the tilt, or easy seepage;
48, pipe wall along the mouth to the use of sets of tearing method, so it looks complete;
49, floor marble should open mart;
50, must be sand floor tiles, slide Do not equitable to see good;
51, matte tiles complicated to clean;
52, to pay care to the drainage tile balcony direction;
53, the keel is best to use dry larch;
54, later a colossal wooden materials bought ambition dry;
55, approach the child 1st playing level carpentry;
56 , color panels come in to buy a paint brush again
57, the shoulder can not be installed in the ceiling hanging keel;
58, ceiling hanging bars from the wall shall not exceed 200;
59, color panel construction to pre-pick color;
60, gypsum board to use self-tapping screws into the board 1-2mm, and anti-rust treatment do not clutch the nail with;
61, the distance between plasterboard fixes may greater than 200;
62, gypsum wall board with a 3mm suture because crack treatment;
63, gypsum board to do the best sun angle at the angle of the sun protection;
64, doors at the upper and lower brow brush to paint;
65, the bottom of the bathroom door pockets to swipe waterproof handbook;
66, the size of the door height should be consistent;
67, furniture, try not to do carpentry,GHD MK4 Pure Straighteners, do can be done;
68, try to buy the whole cabinet, woodworking done well;
69, must consider the good of entire sizes, change up more trouble;
70, make their own shift gates do not do dark orbit, after no course to mend;
71, the bathroom small space, try to do the sliding door;
72, not sure of carpentry, we must communicate more with the foreman, do not let them self-assertion ;
73, money in hand is the last word;
74, have kid at home to use less ground glass;
75, be sure to let workmen take to look the drawings;
76, pantry is pumping conference advantageous;
77, floor flatness wood keel is 5mm;
78, between the floor joints staggered;
79, floors and wall to depart 8-10mm among the joints;
80, compound layer width of more than 8 meters must think the expansion joints;
81, to minimize the use of secret embark do Door;
82, hinges and hardware must use good;
83, Yuba wood to be installed in keel, can not be directly mounted on the dome;
84, in the black paint goes, try not watered, good bad or effortless;
85, gypsum board joints to be above the ribbon;
86 , where there are gaps on the wall truly cool napkin is better;
87, the best to eliminate the aboriginal walls and some putty alternatively glue brush repeatedly Sealing;
88, try to buy a brand paint, elaboration company suggested not known or recommended at the boss do not try;
89, the weather is too wet paint Do not brush;
90, a painter must await ahead the next an after the paint dry;
91,GHD IV Pink Straighteners, paint lustering to wait after entirely dry;
92, the metal behind to do anti-rust dispose;
93, chilly weather, the quality will be penniless painter;
94, paint the door, the use Masking stick hinge and door locks;
95, also hot to pay attention to airing;
96, wallpaper paste, brush the varnish to the wall;
97, wallpaper paste, should the switch , socket panel cleared to;
98, light, silky cream paint to a complete supplement of prone to colorful aberration;
99, hit off the assembly line installed to use putty and draw fill joints;