,
pandora sale
| Back to logs list
Reprinted from 234580661 at 8:48 on August 3, 2010 Reading (loading. ..) Comments (0) Category: Personal Diary
ado, given directly on the satellite TV receiver upgrade crack pot method for a crack pot method: manual search since September 9 in the Star satellite television receiver boot after the upgrade part of the cottage can not complete the automatic upgrade . Power to 39% after the auto search will appear after the Dead phenomenon, this time remote failure can not quit. Attention! This is not a crash. Solution
ado, given directly on the satellite TV receiver upgrade crack pot method
crack pot Method One: manual search
since September 9 in the Star satellite television receiver boot after the upgrade part of the cottage can not complete the automatic upgrade. Power to 39% after the auto search will appear after the Dead phenomenon, this time remote failure can not quit. Attention! This is not a crash.
crack pot Method Two: Restore factory settings
tried it today, the upgrade process does enter the receiver,
pandora online, but if you start the upgrade process, only the serial number from the change to the 06,10001,004 01,1001,004, Upgrading does not change. Then automatically enter the auto search, to 39% after the progress bar does not move. But the frequency has been increasing in the change. You break out. A program has not retained. You do not interrupt launch frequency has been increasing. Crashed the same as the outside.
solution is to enter the settings, return to factory state, password 9999 or 0000. and then into the hand search, did not show a frequency into the frequency 2, the search will have a program,
pandora bracelets, there are three or four frequency programs, 2,
pandora beads,3,
pandora necklace, 4 These three have a frequency of 54 programs. The same as before.
pot crack Method three: cottage upgrade
nine of the machine to machine upgrades,
pandora jewelry, machine tools, one Taiwan. In fact, can now see the machine. Serial line. Only one sub-machine can not upgrade or continue to show the current state of the few sub-update. Step 1 Connect the serial cable to the back of the machine. 2. Machine tools under power --- by three-F4 key. 3. OK. At this point machine tools panel display ON. 4, sub-machine power opens up panel display for the chaos. 5, the upgrade started TOOLS panel display 001-099 in EP finally turned into 001. Upgrade success!
Hybrid Mode
